T5 = Application of wax. T6 = Application of soap. Supersedes;. BS EN BS AMS Phosphate treatment is defined by reference to a particular. Find the most up-to-date version of BS EN at Engineering BS EN October Phosphate conversion coatings of metals. Method of specifying requirements. Historical Version.

Author: Kara Zulkizilkree
Country: Mali
Language: English (Spanish)
Genre: Marketing
Published (Last): 28 May 2016
Pages: 63
PDF File Size: 15.8 Mb
ePub File Size: 10.80 Mb
ISBN: 701-1-81666-179-2
Downloads: 14492
Price: Free* [*Free Regsitration Required]
Uploader: Fenrizil

磷化处理EN 标准(英文版)_百度文库

If necessary, adjust the pH to the desired level by adding solid ammonium chloride. If necessary, scrub the coating off em a rubber wiper. The committee decided to retain the specifications of subclause 7. Filter this off after 10 minutes of heating and rinse thoroughly with hot distilled water.

A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official versions. A comma is used as the decimal marker. A yellow precipitate indicates gs presence of phosphate. EN comprises 12 pages.

TOP Related Articles  DT9205A PDF

Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Management Centre or to any CEN member. Previous editions DIN Using half of the solution, test for manganese by adding 0,5 g of bismuth sodium trioxide, thus oxidizing any manganese present to permanganate; a reddish violet colour indicates the presence of manganese.

To establish that a coating is a manganese phosphate coating, it is sufficient to establish the presence of manganese for ferrous substrates only cf. If neither manganese nor zinc has been detected in a phosphate coating on a substrate of ferrous material, then the coating is certain to be an 124766 phosphate coating.

A white precipitate, which may have a slight green tinge due to the presence of a small amount of iron, indicates the presence of zinc. To identify the purified white precipitate as calcium oxalate, remove it from the filter by spraying with hot distilled water, and then add about 50 ml of distilled water. Add 10 ml of the ammonium molybdate solution and 5 g of ammonium nitrate to the acidified filtrate, and leave the mixture to stand for at least 15 minutes.

TOP Related Articles  FORBIDDEN MENTALISM PDF

Use the other half of the solution to test for the presence of calcium as described in subclause NA. The detection of phosphate in a coating shall be taken as proof that it is a phosphate coating cf.

To establish that a coating is a zinc phosphate or a zinc calcium phosphate coating, it is sufficient to establish the presence of zinc or zinc and calcium, respectively for zinc-free substrates cf. Decoloration of the permanganate solution identifies the precipitate as calcium oxalate, thus indicating the presence of calcium in the coating. To decompose the excess hydrogen peroxide, boil the resulting solution for a few minutes and then cool it to ambient temperature.